Table of Contents
Advertisement
STEP 17
Secure FMT fluid end assembly to existing drive by installing
mount screws (x2) as shown
STEP 18
Re-connect secondary containment line [A] to fluid end
assembly as shown
33
A
STEP 19
Connect all previously installed suction and discharge lines to
the fluid end
Only properly qualified and trained personnel should be involved
in the setting up, putting into service, inspecting and repairing of
this equipment
Ensure National, Provincial/State and local codes are followed
when plumbing equipment. Failure to follow these codes can re-
sult in serious bodily injury or death
Typical installation shown above Please refer to the 'Installa-
tion' section of this manual for a complete item breakdown
CAUTION!
www.mcisolutions.ca
Advertisement
Table of Contents
