www.mcisolutions.ca
GENERAL SAFETY
In-line filter assemblies are available direct from MCI Kits include all tubing
[where applicable] and fittings required to complete the installation Contact
customer service for more information: +1 888 263 4565
Power Supply
When wiring the System follow cable orientation labels found on the inside of
the enclosure lid Failure to orientate wiring properly may result in damage to
the on-board electronics and could cause serious bodily injury or death
To protect the System and associated components the pump box must be
connected to ground All electrical connections must satisfy National, Provin-
cial/State and local electrical codes
SYSTEM CAN START AUTOMATICALLY - Before connecting power to the
control board ensure that you and all tools used in setup are clear of moving
parts, serious bodily injuries can occur
When connecting cables to the control module ensure keyed connections
are tight Loose connections can cause arcing and erosion which destroy the
integrity of the connections
12
The 1/4" NPT drain port shown [Arrow] is a general
System drain port [DO NOT PLUG OFF] This port
must remain open or plumbed to a designated
containment area
Without routine maintenance it is possible for seal
bypass from the low pressure side to exit this port
Ensure proper containment areas are in place and
suggested routine seal maintenance procedures
are followed to prevent spills