Table of Contents
Advertisement
12 V BATTERY
Procedure for charging your battery
when it is fl at or for starting the engine
using another battery.
The presence of this label indicates the
use of a 12 V lead-acid battery with spe-
cial technology and specifi cation, for
which the involvement of a PEUGEOT
dealer or qualifi ed workshop is required
when replacing or disconnecting the
battery.
Failure to observe this recommendation
may cause premature wear of the battery.
After refi tting the battery, the Stop & Start
system will only be active after several
hours depending on the climatic condi-
tions and the state of charge of the battery
(up to about 8 hours).
The Stop & Start battery does not have
to be disconnected for charging.
Access to the battery
The battery is located under the bonnet.
To gain access to it:
open the bonnet using the interior
release lever, then the exterior safety
catch,
secure the bonnet stay,
remove the plastic cover to gain ac-
cess to the two terminals,
unclip the fusebox to remove the
battery, if necessary.
Starting using another battery
Connect the red cable to the posi-
tive terminal (+) of the fl at battery A ,
then to the positive terminal (+) of
the slave battery B .
Connect one end of the green or
black cable to the negative termi-
nal (-) of the slave battery B .
Connect the other end of the green
or black cable to the earth point C
on your vehicle (engine mounting).
Operate the starter, let the engine
run.
Wait until the engine returns to idle
and disconnect the cables.
Advertisement
Table of Contents
