Advertisement
6800 LOW PROFILE PUSH/PULL LATCH
SQUARE
-OR-
ROUND
COVER
(2) 8-32 X 3/8"
PHILLIPS FLAT HD. M.S.
(2) PER COVER
MAKE CERTAIN BOLT
BEVEL FACES THE
DIRECTION OF DOOR
CLOSING
(2) #8 OR 8-32 SCREWS
INSTALLATION INSTRUCTIONS
1.
PUSH/PULL LATCHES ARE ASSEMBLED FOR RIGHT HAND AND LEFT HAND DOORS. BE SURE CORRECT SIDE
MATCHES DOOR APPLICATION.
2.
PLACE LATCH BOLT UNIT IN DOOR MAKING SURE BOLT BEVEL FACES DIRECTION OF DOOR CLOSING.
ATTACH FRONT WITH TWO (2) #8 OR 8-32 SCREWS DEPENDING ON DOOR.
3.
POSITION LEVER ASSEMBLIES SO THAT LOCATING PIN AND CAM ARM ENTER INTO CORRESPONDING HOLES
IN LATCH BOLT UNIT. ATTACH LEVER ASSEMBLIES BY THRU BOLTING ONTO DOOR WITH FOUR (4) #10-32 X
2-1/4" PHILLIPS PAN HD. M.S. AND FOUR (4) #10-32 KEP NUTS. FOR PURPOSE OF ALIGNMENT DO NOT
TIGHTEN SCREWS UNTIL ALL FOUR (4) SCREWS HAVE BEEN STARTED.
4.
APPLY COVERS AND FASTEN WITH (2) 8-32 X 3/8" FLAT HD. M.S. FOR EACH COVER.
5.
INSERT DUST BOX IN FRAME MORTISE AND ATTACH STRIKE WITH TWO (2) #8 OR 8-32 SCREWS.
TO CHANGE DIRECTION OF PUSH OR PULL HANDLE
NOTE: REVERSE INSTALLATION INSTRUCTIONS #4 & # 3 THEN CONTINUE
WITH INSTRUCTIONS 1, 2 & 3 BELOW.
1.
REMOVE THE (2) 10-32 SHOULDER BOLTS WITH SPRINGS THAT SECURE
THE CAM HOLDER ASSEMBLY, NOTE THE DIRECTION OF THE LOCATING
PIN BEFORE STARTING.
2.
ROTATE THE CAM HOLDER ASSEMBLY 180°.
3.
REINSTALL THE (2) 10-32 SHOULDER BOLTS WITH SPRINGS.
PATENT PENDING
O
(4) 10-32 KEP NUTS
TYPICAL FINISHED
DOOR PREPARATION
www.abhmfg.com
R
E-mail: abhinfo@abhmfg.com
Architectural Builders Hardware Mfg., Inc.
1222 Ardmore Ave., Itasca, IL 60143
630.875.9900; FAX 800.9FAXABH (932.9224)
PULL SIDE
LATCH BOLT UNIT
(4) 10-32 X 2-1/4 "
PHILLIPS PAN HD. M.S.
c 2014 ABH Mfg., Inc.
printed in USA
U
L
LOCATING PIN GUIDE
PUSH SIDE
10-32 SHOULDER BOLTS
WITH SPRINGS
CAM HOLDER
LOCATING PIN
6800-4
REVISED 09-16-14
LISTED
6800-4-04.DWG
Advertisement
