Advertisement
2. The first time you use the solderhg iron, it may smoke slightly as
the heating element dries out. This is normal and should only last for
approx. 10 minutes.
3. Never file the specialy-plated tip.
3. MAINTENANCE
This tool must be placed on its stand when not in use.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
TIP REPLACEMENT
Note: Tip replacement or cleaning should be done only when the iron
is at room temperature or below. The tip can be changed or replaced
simply by unscrewing the knurled nut barrel assembly.
The station must be switched off and allowed to cool before and
during this operation, as damage may occur if the system is left on
without the tip inserted, after removing tip, remove any oxide dust that
may have formed in the tip retaining area of the barrel. Be careful to
avoid getting dust in your eyes. Replace the tip and screw the
retaining knurled nut barrel assembly using only hand pressure to
tighten. Pliers should only be used to tighten the nut if loosening occur
when the iron is hot to avoid burning your fingers. Do not over tighten
as this would damage the element.
GENERAL CLEANING
The outer case of the iron or station may be cleaned with a damp
cloth using small amounts of liquid detergent. Never submerse the
unit in liquid or allow any liquid to enter the case of the station. Never
use solvent to clean the case.
1. The appliance is not a toy, and must be kept out of children's
hands.
2. Before cleaning the appliance or changing the filter, always remove
the power lead plug from the socket. Unserewing the housing is not
permitted.
3. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person
responsible for their safety.
4. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid hazard.
www.tmatlantic.com
4
Advertisement
