Setting The Auto Mode - Decagon Devices KD2 Pro Operator's Manual

delayed start times, and the number of measurements from
this menu.
To configure Auto Mode with the KD2 Pro Utility:
1. Connect your KD2 Pro to an available serial communica-
tion port on your computer. Select the name of your cho-
sen serial port in the "Use computer communication
port" control.
2. Choose "Configure Auto Mode..." from the Actions
Menu. The following screen appears:
3. Choose values for Measurement Interval, Start Time, and
Number of Measurements. Each of these values is
explained below.
KD2 Pro Operator's Manual
4. The KD2 Pro Utility
33