Table of Contents
Advertisement
HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM
ALL WIRING MUST CONFORM TO APPLICABLE LOCAL
CODES, ORDINANCES, AND REGULATIONS.
DO NOT ROUTE COMMUNICATION WIRES WITH POWER
OR LOCKING DEVICES.
Power over Ethernet (PoE) wiring
PoE integrates data and power on the same wires, without interfering with concurrent network operation. PoE delivers 48V of DC
power over unshielded twisted-pair wiring for terminals consuming less than 13 watts of power.
PoE can be used with IEEE 802.3af compliant devices in either of the two modes described in Table.3 and shown in Fig.19 and
Fig.20. The detailed pin-outs are shown in Table.4.
P
N I
1
Fig. 19. Straight cable pinouts for PoE in Mode A
95-7767
NOTE: FOR COMMUNICATION CIRCUITS AND OTHER
P
N I
8
24
APPLICABLE WIRING CIRCUITS WHERE WIRING
ENTERS AND EXITS THE BUILDING, REFER TO
TABLE 13 FOR APPROPRIATE LIGHTNING PRO-
TECTOR USAGE.
PIN 1
Fig. 20. Straight cable pinouts for PoE in Mode B
PIN 8
Advertisement
Table of Contents
