Lightning Protection - Honeywell IdentIPoint Installation Instructions Manual

Intelligent smartcard system

Hide thumbs Also See for IdentIPoint:

Quick installation manual (32 pages)

Table of Contents

HONEYWELL IDENTIPOINT™ INTELLIGENT SMARTCARD SYSTEM

3. Click Test. The selected color blinks on the LED.

4. Click Exit. Exit from the LED test window.

To perform keypad test:

1. Click Keypad Test from the Diagnostics and Tools list.

The Keypad Test window is displayed.

2. Click Test to initiate the test.

3. Type any 'num' keys on the keypad. The same text is

displayed on the LCD of the reader.

4. Click Exit to close the page.

To perform IO test:

1. Click IO Test from the Diagnostics and Tools list, the

IO Test page is displayed.

2. For testing the output points select an output point from

the Output Point drop-down list.

a. Select a state from the State drop-down list.

b. Click Command, to set the command. The device

connected to the respective output point is set to the

appropriate selected state.

3. For testing the input points select an input point from the

Input Point dropdown list.

a. Click Read, to read the input channel status.

b. The state of the device that is connected to the input

point is displayed in the Current State text box.

To reboot the reader:

1. Click Reboot Reader from the Diagnostics and Tools

list. The Reboot Reader page is displayed.

2. Click Reboot, reboots the card reader.

To check the IP:

NOTE: The availability of an IP address is checked on

Ethernet and Wireless page.

1. Click Ping from the Diagnostics and Tools list on Ether-

net or Wireless page. The Ping page is displayed.

2. Type the IP to be searched in IP address to ping text

box.

3. Click Ping. The result is displayed on the Ping result

window.

To perform a factory reset on the reader:

1. Keeping the reader powered on normally, remove it from

the back-plate and find the factory reset switch at its

back (see Fig.3).

2. Press the factory reset switch for 10 seconds or more

until the reader LED/LCD is turned off.

3. When the LED/LCD is off, release the factory reset

switch.

4. Wait for the reader to restart.

5. If using an LCD model, the Honeywell banner will

appear on the display for a few seconds and then disap-

pear.

95-7767

6. Within 1 minute, the reader LED will start flashing green

indicating that the reader has been reset to the factory

firmware.

7. If using an LCD model with a DHCP server connected

via Ethernet, the following will appear on the display

within 1 minute:

Honeywell

IdentIPoint

Version: 1.0.18.0

aaa.bbb.ccc.ddd (where "aaa.bbb.ccc.ddd" is the IP

address assigned by DHCP)

8. If using an LCD model WITHOUT a DHCP server con-

nected via Ethernet, the following will appear on the

display within 3 minutes:

Honeywell

IdentIPoint

Version: 1.0.18.0

<blank> (no IP address assigned)

NOTE: In case factory reset fails (which might happen if

the factory reset switch is not released in time at

step 3), the reader will beep multiple times while

it is restarting. Afterwards it will not respond

when a card is presented.

To recover from factory reset failure:

1. Power off the reader and power it on again.

2. Wait for the reader to start in normal mode.

3. Repeat all the required factory reset steps above.