Advertisement
Set Up
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY:
Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL STARTING: Make sure that the Engine is switched OFF,
wait for the Engine to cool, and unplug the spark plug wire before performing any procedure in this section.
At high altitudes, the engine's carburetor, governor (if so equipped), and any other parts that control
the fuel-air ratio will need to be adjusted by a qualified mechanic to allow efficient high-altitude
use and to prevent damage to the engine and any other devices used with this product.
Note: For additional information regarding the parts listed in the following pages,
refer to Parts Lists and Diagrams on page 18.
Mounting the Chisel
1. Apply grease to the loading end of the Chisel.
2. Pull out the Chisel Lock and insert the Chisel into
the Chisel Base with the flat notch facing up. Slide
the Chisel in as far as it will go. Refer to Figure A.
3. Turn the Chisel Lock 180° and release
to lock the Chisel into place.
Page 6
For equipment technical questions, please call 1-888-866-5797.
Chisel Base (118)
For engine technical questions, please call 1-800-520-0882.
4. When the Chisel is installed, there will be
approximately 1-1/4" of play along the flat
notch of the shank but it should not come
out when pulled. Physically check that
the Chisel is secure before operating.
Play
Chisel
Flat Notch
Chisel Lock (119)
Figure A
ITEM 61924
Advertisement
