3.1
General
The SmartPicker is characterized by:
-
Divider 1 ... 65535
-
Single Pulse Check
-
Input Power Check
-
Build in photodiode
-
Synchronize up to 200MHz
-
Stable EMC shielded aluminium case
-
Integrated USB port
-
Trigger-Level input down to 50mV
-
TTL monitor output
-
Variable delay in the range 0 ns ... 1 ms
-
Variable pulse width in the range 12 ns ... 1 ms
The device is intended for use as table top device. It must be used in horizontal position. Please
protect it against shifting.
3.2 AOM-output (SMA)
Connector:
Voltage:
Current:
T
Rise
A driver for acusto-optical modulator (AOM) needs typical TTL voltage pulses for switching between the off
and on states. The exact value is given in the data sheet of the AOM – Driver.
The AOM-output is optimized for an output impedance of 50 Ω. Shortening the output may lead to
irreparable device damage.
The AOM-output is optimized for an output impedance of 50 Ω. For other output impedance values
the voltages are not correct.
3.3 AOM-MONITOR (OUTPUT)
Connector:
Voltage:
Current:
T
Rise
Manual SmartPicker AOM Rev. A ENG
Output
SMA(f)
TTL
± 100 mA
/ T
:
< 1.5 ns
Fall
Output
SMA(f)
TTL
± 100 mA
/ T
:
< 1.5 ns
Fall
(square wave)
(square wave)
-9-
LaCoSys Nov 2017