Table of Contents
Advertisement
4
Use of the device
4.1
Unpacking and installation
Please verify the packaging if it is damaged. Any damage must be announced to the carrier and the
manufacturer after receipt. Please verify if the package is complete:
Description
SmartPicker tabletop device
Mains cable
Documentation (manual, usb-stick)
Power supply
4.2 First steps
Connect the mains cable with the delivered power supply and connect the DC-Pug to the device.
Only use the delivered power supply!
Connect a USB A-B – cable with the device and your PC.
You may need administrator rights to install the necessary software drivers depending on the
operating system.
The software driver installation proceeds automatically if Microsoft Windows 7 or higher is used. For more
information please read chapter 4.3.
A possible set-up of the SmartPicker AOM with a AOM-Driver and modulator is depicted in Fig. 4. Your set-up
may differ from this. The oscilloscope can used on monitor ports for the visibility of the electrical pulses for
modulator control.
Manual SmartPicker AOM Rev. A ENG
Fig. 4:
Scheme of a set-up
-12-
Number
1
1
1
1
LaCoSys Nov 2017
Advertisement
Table of Contents
