Table of Contents
Advertisement
4.3 Installation of software drivers
A virtual COM-port driver is needed for the communication via USB. For systems of Microsoft Windows 7 or
higher the driver installs automatically if the PC is connected with the Internet. To do this you must only
connect the USB-cable. The driver installs automatically. It is not necessary to switch the SmartPicker AOM on.
This process can take some time.
For all other systems the drivers must be downloaded from the website of the driver manufacturer:
http://www.ftdichip.com/Drivers/VCP.htm . Please connect the USB cable after the drivers installation.
A new COM-port is displayed in the device manager of your system after successful installation.
You may need administrator rights to install the necessary software drivers on your PC depending on
the operating system. Please contact your IT-service.
4.4 Installation of LabView SmartControl AOM
The SmartPicker is controlled by SmartControl AOM Software.
For installation please start the setup.exe on delivered USB-Stick and follow the instructions.
4.5 Software description
Manual SmartPicker AOM Rev. A ENG
-13-
LaCoSys Nov 2017
Advertisement
Table of Contents
