Figure 3-13. Attaching Retention Brackets To Gpu Cards - Supermicro SBI-7126TG User Manual

7. Attach retention brackets to the back of each of the GPU cards with two (2) screws
each (see Figure
serverboard for assembly installation into the bottom blade chassis.

Figure 3-13. Attaching Retention Brackets to GPU Cards

NOTE: The SBI-7126TG blade module uses a different size and type of
brackets for each of the GPUs installed in the module. Use (part #
MCP-640-00062-0N) for the right GPU and (part # MCP-640-00062-0N) for the
left GPU (for the orientation as shown in
8. (Optional) Install the SATA DOM module and its associated power cable before
replacing the front assembly back on the blade module at this time. See
Drives" on page 4-8
9. Reattach the Riser Card/Front Blade Assembly back into the blade module.
Resecure it with its fourteen (14) retaining screws and screw the two retention
bracket screws to the GPUs and the serverboard (see
10. Install the two GPU card power cables for each GPU card. One end attaches to the
GPU card's 8-pin socket, the other end attaches to the power socket on the blade
module's serverboard.
11. Replace the top cover and secure it with its one retention screw (see
3-13). Also unscrew the retention bracket screws from the module
in Chapter 4 for details.
3-15
Chapter 3: Setup and Installation
Figure 3-13 above).
step 7).
"Hard Disk
Figure 3-8).