Advertisement
Available languages
Available languages
4. Carefully reassemble the ozone cell making sure the rubber
seal is seated correctly around the ceramic plates.
5. Replace the 6 screws and loosely tighten them so that the
spring washers are just touching the black heat sink. The
screws should easily screw in but if you feel that any screw
is more resistant than others, try adjusting/wobbling the
black heat sink slightly until this situation is resolved.
6. Now tighten evenly the 6 screws, starting with the two in
the middle so that the spring washers are completely
compressed. Do not over-tighten any of the screws. Your
2
V
Ozone Generator is now ready to be connected to your
system and used again.
12 Month Warranty
• Proof of purchase including place and date will be
required.
• Warranty and liability are limited and cover only the
2
V
Ozone Generator.
• The warranty is void if the plastic case of the
2
V
Ozone Generator has been opened.
• Damage from misuse, accident, neglect or operation
of your V
the instructions in this manual is not covered under
this warranty.
• The terms of this warranty do not affect your
statutory rights.
2
Ozone generator NOT in accordance with
10
Advertisement
