Boston Scientific LATITUDE 6280 Patient Manual page 30

Important: For the following steps, make sure
you use the Ethernet cable provided with the USB
Ethernet Adapter and not the telephone cord provided
with the Communicator.
3. Insert the narrow end of the USB cable (included
with the USB Ethernet Adapter) into one of the
USB ports on the Communicator labeled
4. Insert the square end of the USB cable into the
end of the USB Ethernet Adapter nearest the
adapter light.
5. Insert the Ethernet cable (included with the USB
Ethernet Adapter) into the opposite end of the
adapter.
6. Plug the Ethernet cable into an Ethernet port for
your Internet service, such as a modem, router, or
Ethernet wall jack.
• Confirm that the USB Ethernet Adapter is
properly connected by verifying the green light
on its front is lit (solid or flashing).
7. When the Heart button flashes, press it.
• Your Communicator's wave lights will flash
green in sequence and repeat for several
minutes as shown in "Indicator Sequence When
Using the Heart Button" on page 29.
• If you have previously completed initial setup,
the Heart button will not flash at this point.
26
LATITUDE Communicator Patient Manual
®
.