Cleaning The Trimmer - Philips S1070 Manual

Be careful with hot water. Always
check if the water is not too hot, to
prevent burning your hands.
Never dry the shaving unit with a
towel or tissue, as this may damage
the shaving heads.
1 Hold the shaving unit and first lift
the front, then the back upwards
of the appliance (Fig. 13).
Note: Make sure to hold the
shaving unit while doing so.
2 Rinse the hair chamber under the
tap (Fig. 14).
3 Rinse the inside of the shaving
unit under a warm tap (Fig. 15).
4 Rinse the outside of the shaving
unit under a warm tap (Fig. 16).
Thorough cleaning
5 Turn the lock anticlockwise and
remove the retaining frame from
the shaving unit (Fig. 17).
6 Remove and clean one shaving
head at a time (Fig. 18). Each
shaving head consists of a cutter
and a guard.
Do not clean more than one
cutter and guard at a time, since
they are all matching sets. If you
accidentally mix up the cutters
and guards, it may take several
weeks before optimal shaving
performance is restored.
7 Remove the cutter from the
shaving guard and rinse it with
water (Fig. 19).
8 Rinse the inside and outside of
the shaving guard with water (Fig.
20).
9 Put the shaving heads back into
the shaving unit (Fig. 21). Make
sure that the projections of the
shaving heads fit exactly into the
recesses.
10 Put the retaining frame back into
the shaving unit and turn the lock
clockwise (Fig. 22).
11 Reattach the shaving unit (Fig. 23).
Note: If you cannot reattach the
shaving unit properly, check if you
have inserted the shaving heads
properly and if the retaining frame
is locked.
12 Carefully shake off excess water,
open the shaving unit again and
leave it open to let the shaving
unit air dry completely.
Caution: Be careful not to hit the
shaving unit against anything
while you shake off excess water.

Cleaning the trimmer

Clean the trimmer every time you
have used it.
1 Switch off the appliance and
disconnect it from the wall socket.
2 Push the trimmer release slide
downwards to open the trimmer
(Fig. 10).
3 Rinse the trimmer under the tap
(Fig. 24).
4 Carefully shake off excess water
and let the trimmer dry.
5 Close the trimmer ('click') (Fig. 12).
Tip: For optimal trimming
performance, lubricate the trimmer
teeth with a drop of sewing machine
oil regularly.
Storage
We advise you to let the appliance
dry before you put the protection cap
on it.
1 Switch off the appliance.
2 Put the protection cap on the
shaving unit after use to prevent
damage and to avoid dirt
accumulation in the shaving
heads (Fig. 26).