Hamilton Beach FlexBrew Operator's Manual page 11

How to Program for "Wake Up" Coffee
1
Select regular or bold and your
cup size.
5
Press and release PROG button
again to set autostart.
840274900 ENv02.indd 11
PROG
2
Add water to the reservoir. Add
coffee (ground or single-serve
pack) and put cup in place.
6
(After the Time Has Been Set)
3
For the first time you program,
press and hold PROG button for
3 seconds until "19:99" flashes on
display.
The blue light on the side of the
PROG button will illuminate to
indicate the unit will automatically
start at your desired time. After
the program autostart time has
been set, the autostart sequence
can be toggled on/off by pressing
the PROG button for less then 1
second. To review the autostart
time, press the PROG button
and hold for 3 seconds. After the
initial program setting, time will
default to the last programmed
autostart time set. Once in
PROG mode, cup size and brew
strength cannot be changed until
PROG mode has been turned off
by pressing the PROG button.
4
Continue to hold the PROG button
and also press the button.
"12:00" will flash on display. Set
time according to "How to Set
the Time for the First Time" on
Page 10.
11/4/2016 9:53:17 AM
11