Panasonic VBHN330SA17E General Installation Manual page 21

Using a Grounding Clip with bolt
and nut
(see Figure 16-4.)

Use Tyco Electronics 1954381-2 as
grounding clip.

Place the grounding clip onto the
module frame.

Thread the hex nut onto the end of
the screw, then using a 3/8-in.
wrench, tighten the nut.
Recommended torque value in
tightening bolt and nut is between
1.7 and 2.2 Nm.

Insert the wire into the wire slot.
Press down on both ends of the
wire.

Manually, or using channel lock
pliers, push the slider over the base
until it covers the base. This will
terminate the wire.
Using a Grounding Clip with bolt and nut
For more information, please refer to
Instruction sheet issued by Tyco Electron-
ics.
Figure 16-4.
21
Note: Use the ground holes
illustrated in Figure 16.1.
Grounding Clip Assemblies:
Tyco Electronics 1954381-2