Zanussi ZWT 71201 WA User Manual page 26

16-22 mm
Ø 35 mm
14 mm
Hinges
To mount the hinges drill two holes (dia. 35 mm,
depth 12.5-14 mm depending on the depth of door
furniture) on the inner side of the door.
To fix the hinges to the door use the screws for
wood 1 and 2 supplied with the appliance (see
below).
The distance between the holes hobs fixing centres
must be 416 mm. The distance from upper edge of
the door to the centre of the hole depends on the
adjacent furniture's dimensions.
Door mounting
To mount the door fix the hinges to the appliance
using the M5x15 screws.
Do not remove the screw B !!
The hinges can be adjusted to compensate for
possible uneven thickness of the door.
26
X
416
mm
22±1,5 mm
595-598 mm
2
1
B
To align the door perfectly, loosen the screw, adjust
the door and tighten the screw A again.
The appliance is prearranged for a magnetic
closure of the door. To enable a correct operation
of this device, screw the counter-magnet A (steel
disk + rubber ring) into the inner side of the door.
Its position must correspond to the magnet B on
the appliance.
Do not remove the screw C !
If the door has to be opened from left to right, invert
the position of the plates E, the magnet D and the
plate C.
Mount the counter-magnet D and the hinges A as
previously described.
Do not remove the screw B!
A
A
B
C