Unit Start/Stop; Start From The Keypad - MTA TAEevo Tech 015 Operating And Maintenance Manual

On the models TAEevo Tech 015÷351 the electronic control unit is installed on the door of the electrical panel, while on
models TAEevo Tech 381÷802 it is fitted inside the electrical panel while the door is equipped with LCD graphic display.
Electronic control TAEevo Tech 015÷351
NOTE
To convert the semi-graphic LCD display on the door of the electrical panel (mod. TAEevo Tech 381÷802) to remote control,
the relevant remote control kit must be ordered.
0 . 1 U n i t s t a r t / s t o p
The unit can be switched on and off as follows:
• From the keypad (local or remote)
• From a digital input configured as remote ON/OFF
NOTE
In case of a power loss, when power is restored the unit will be ON if it was ON at the time of power loss, and OFF if it was
OFF.
0 . 1 . 1 St a r t f ro m t h e k e y p a d
From unit OFF (stand-by) press and release button
is lit.
Stand-by mode is set each time the unit is switched off from chiller operating mode. Also in stand-by the controller makes it
possible to:
• Display the measured values.
• Manage the alarm situation by displaying and signalling active alarms.
When the unit is in stand-by the controller shows the label
TAEevo Tech 015÷802 60 Hz UL
to switch the unit on or off in chiller mode. With the unit on LED
The data in this manual are not binding and they can be modified by the manufacturer without notice. Reproduction of this manual is strictly prohibited
LCD graphic display TAEevo Tech 381÷802

 on the display.
OPERATING AND MAINTENANCE MANUAL
- User's quick guide
2
EN