oticon Opn S 1 miniRITE R Instructions For Use Manual page 39

This Class B digital apparatus
complies with Canadian ICES-003.
Note: This equipment has been
tested and found to comply with
the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harm-
ful interference in a residential in-
stallation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful interference to ra-
dio communications. However, there
is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
76 About Start-up Handling Options Tinnitus Warnings
by turning the equipment off and on,
the user is encouraged to try to
correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving
antenna.
– Increase the separation between
the equipment and receiver.
– Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
– Consult the manufacturer or an
experienced radio/TV technician
for help.
More info
The manufacturer declares that this
hearing aid is in compliance with the
essential requirements and other
relevant provisions of Directive
2014/53/EU.
Waste from electronic
equipment must be
handled according to
local regulations.
Declaration of Conformity is
available from the manufacturer.
Manufactured by:
Denmark
77