Set-Up Via Front Keys - Kamstrup MULTICAL 403 Installation And User Manual

10 Set-up via front keys

It is possible to set up a number of parameters in MULTICAL® 403 at the installation site. The
setup is carried out via the SETUP loop that is available as long as MULTICAL® 403 is in transport
state*, or until you finish the setup with "EndSetup". If the meter has been put into operation and
is thus no longer in transport state, it is necessary to break the meter's installation seal to be able
to access the SETUP loop again. This is done by separating and immediately after reassembling
the top and base of the calculator. Thereafter, the meter must be sealed with sealing wire and/or
sealing label to be used for billing purposes.
You go from USER loop to SETUP loop by pressing the left key (primary key) for 9 s. After 4 min.
without activation of the front keys the meter returns to energy reading in USER loop.
SETUP loop does not include secondary readings, and, therefore, the index number always
consists of 4 digits. In SETUP loop the right key (secondary key) is used for accessing individual
readings with the purpose of changing
SETUP loop
1.0 Customer number (N
2.0 Customer number (N
3.0 Date
4.0 Time**
5.0 Yearly target date 1 (mm.DD)
6.0 Monthly target date 1 (DD)
7.0 Flow sensor position: inlet or outlet flow (A-code)
8.0 Measuring unit and resolution
(B and CCC-codes are configured as e.g. "0.001 MWh" and "0.01 m
9.0 M-Bus primary address (N
10.0 Average time for min./ max. P and Q
11.0 q
***
hc
12.0 t offset
13.0 Radio "ON" or "OFF"
14.0 Input A (pre-set register)
15.0 Input B (pre-set register)
16.0 Meter no. of Input A
17.0 Meter no. of Input B
18.0 TL2
19.0 TL3
20.0 TL4
21.0 t5
22.0 EndSetup
* MULTICAL® 403 remains in transport state until flow is registered for the first time.
** The clock can be adjusted under installation seal via the front keys or the PC-program
METERTOOL HCW. Furthermore, all modules can adjust the clock.
*** q
can only be changed in meters configured as meter type 6. Upon attempts to access this
hc
menu in meters configured with other country codes the display shows the message "Off".
Kamstrup A/S • 55121739_A4_GB_11.2017
parameters.*****
o 1)
2)
o
35)
o
MULTICAL® 403
Index number in
display
3-001
3-002
3-003
3-004
3-005
3-006
3-007
3-008
")
3
3-009
3-010
3-011
3-012
3-013
3-014
3-015
3-016
3-017
3-018
3-019
3-020
3-021
3-022
21