Install Carburetor - Briggs & Stratton 030430 Service And Repair Manual

Install Carburetor

NOTE: Always replace air cleaner gaskets and carburetor
mounting gaskets any time the carburetor has been removed
for service.
1. Position new gasket on studs with long edge of gasket
opposite fuel inlet of carburetor.
2. Hook governor spring (B, Figure 37) in throttle lever
hole without grommet. Hook governor link (A) in
throttle lever hole with grommet.
Figure 37
3. Hook choke link into outer hole of choke shaft from
underneath. Slide other end of choke link into slot in
governor control bracket.
4. Position carburetor on engine. Install screws or nuts
and torque to values listed in Engine Specifications.
5. Connect fuel hose to carburetor and secure with hose
clamp.
6. Using new gasket, install air cleaner assembly to
carburetor.
7. After final carburetor adjustment (last step below),
use Knockout Pin #19135 (A, Figure 38) to install new
limiter cap (B) with flat side facing up.
Figure 38
34 BRIGGSandSTRATTON.COM