Advertisement
1.4. COOKING
(gas and electric models)
Boiling intensity can be set with power regulator "R".
The positions available are:
: Tank heating off;
1...5
: low - medium power;
6...8
: medium - high;
I
: maximum power;
• Fill the water tank;
• Turn knob "C" to "2" or "3".
• Light the burner (gas versions);.
• Turn knob "R" to the desired setting;
• When boiling, add salt (in order to prevent corrosive
deposits on the bottom of the tank make sure to use
refined salt and if this is not possible dissolve it in water
in a separate container).
• Introduce the baskets with food to be cooked in the tank.
• Operate knob "R" adjusting the tank heat according to
the quantity and quality of food to be cooked.
N.B.: the choice of a different power level to "I" involves
turning tank heating off and on again. On a visual level
there may be a variation in boiling of the water without
affecting cooking, guaranteeing energy-saving.
• When cooking is over, turn off the power supply by turning
knobs "C" and "R" to the Off position, switch off the pilot
burner (only for gas versions).
22
1.5. WATER DISCHARGE
After cooking, empty the water tank by operating discharge
lever "S" to reduce the possibility of corrosive deposits inside
the tank.
CAUTION! It is advisable to carry out this operation after
allowing the machine to cool (the inertia of heating, even if
switched off, can damage the tank if empty). If this is not
possible, fill the tank with cold water at the same time
during the cooking water discharge phase.
1.6. MODELS WITH INSTANTANEOUS
HEATER
The "Rapid System" pasta cooker has a 2.8kW rapid boiler
without storage, that provides hotter water (about 40 degrees
higher than the normal inlet water temperature) in the slow
water filling phase (knob "C" in position "3").
This guarantees a lower impact with the temperature of the
water already present in tank, better energy-saving and
shorter time in bringing to boil.
1.7. MODEL WITH COOKING TIMER
ACOUSTIC SIGNAL
•
Set the cooking time by rotating timer knob "T".
•
Press button "D" to start the programmed cooking
cycle. At the end of the cooking cycle, the appliance
emits a 20-second acoustic signal.
•
To repeat the same cycle, do not reset the time, but
simply press button "D".
T
D
Advertisement
