Table of Contents
Advertisement
1. Remove the drip tray (fig. 35).
2. Remove the cup grille (A7), the drip tray grille (A12) and
the drip tray water level indicator (A14), empty the water
and clean the tray with a cloth, then reassemble the drip
tray.
3. Put the drip tray back in place.
11.3 Cleaning the small cup grille
1. Extract the grille (A10) by pulling it from the left, then re-
moving it from the support (fig. 36).
2. Clean the support with a cloth and wash the grille (dish-
washer safe).
3. Put the grille back on the support from the right side, then
push until it is correctly attached (fig. 37).
2
1
11.4 Cleaning the coffee filters
Clean the coffee filters weekly:
1. Extract the perforated filter by pulling the tab (fig. 38).
2. Rinse the filters under running water (fig. 39).
3. Make sure the holes are not blocked. If necessary, clean
with a pin (fig. 40).
4. Place the perforated filter back in the filter housing and
press as far as it will go.
2
2 2
36
38
11.5 Cleaning the boiler outlet
After every 200 coffees, rinse the boiler outlet: Press the rinsing
button (B4) until around 500 ml of water is delivered.
11.6 Cleaning the water tank
1. Clean the water tank regularly (about once a month) and when-
ever you replace the water softener filter (C6) (*if present) with
1
1
a damp cloth and a little mild washing up liquid.
2. Remove the filter (*if present) and rinse with running
water.
3. Replace the filter (*if present), fill the tank with fresh water
and replace the tank.
37
4. (Models with water softener filter only) Deliver about 100
ml of water.
Danger!
While cleaning, never immerse the coffee maker in water. It is an
electrical appliance.
11.7 Cleaning the beans container
1. Make sure the beans container (A2) is empty, then release
by turning it anticlockwise and extract from the appliance.
2. Wash the container and lid (A1) with warm water. Do not
wash the components in a dishwater or use washing up
liquid! Dry all accessories thoroughly before using again.
3. Remove coffee residues (fig. 44).
4. Put the container back as described in section "3. Setting
up the appliance".
11.8 Cleaning the burrs
1. Empty the beans container (if necessary, using a vacuum
39
cleaner to remove any remaining beans).
2. Attach the filter holder and operate the mill without beans
to free the coffee guide: attach the filter holder to the outlet
of the coffee mill (A22) aligning it with "INSERT", then turn-
ing it to the right (fig. 22). Grinding begins when the filter
holder reaches the CLOSE position and stops automatically.
3. Remove the beans container as described in the previous
section "11.7 Cleaning the beans container".
12
40
Hide quick links:
Advertisement
Table of Contents
