Greenlee 555 Series Service Manual page 8

Service Instructions (cont'd)
Outer Control Box
1. Remove the two screws at the bottom front of the
control box (right side of bender).
2. Remove the two screws at the top rear of the
control box and remove the wire cover.
3. Lift the outer control box up and outward.
4. Pull off the two motor leads from the circuit board
noting their orientation.
5. Pull off the encoder cable from the circuit board
(DX model only).
6. Reassemble in reverse order noting the following:
Connect motor leads to same tabs as removed
from.
Greenlee / A Textron Company
555 Series Electric Benders
®
Inner Control Box
1. Remove or loosen roller stop plate (refer to previous
instruction).
2. Remove outer control box (refer to previous
instruction).
3. Remove seven screws and rear chain guard.
4. Remove seven screws and front chain guard.
5. Remove the conduit nut securing the SealTite
conduit to the control box.
6. Remove the hex nut inside the chain guard and
back out the three screws holding the control box.
7. Slide out the inner control box.
8. Reassemble in reverse order.
Front Drive Chain
1. Remove the roller stop plate (refer to previous
instruction).
2. Remove the seven screws and the front guard.
3. Remove the plastic chain stay roller.
4. Remove the center two screws securing the chain
guard stiffener along with the three screws holding
the back guard, and remove the back guard.
5. Remove the master link and chain.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070