Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Trotec TTK 72E
Summary of Contents for Trotec TTK 72E
- Page 1 TTK 53 E / TTK 72 E OPERATING MANUAL DEHUMIDIFIER...
-
Page 2: Table Of Contents
EU declaration of conformity via the following link: Notes regarding the operating manual......... 2 Safety .................. 2 Information about the device.......... 4 TTK 53 E Transport and storage............ 6 Assembly and installation............. 6 https://hub.trotec.com/?id=42189 Operation ................ 8 Errors and faults.............. 12 Maintenance ................ 13 TTK 72 E Technical annex.............. 17 Disposal ................ 17 https://hub.trotec.com/?id=41804... - Page 3 Trotec. • Make sure that the air inlet and outlet are not obstructed. • Make sure that the suction side is kept free of dirt and loose objects.
-
Page 4: Information About The Device
Residual risks Information about the device Warning of electrical voltage Description of the device Work on the electrical components must only be The device uses the principle of condensation to automatically carried out by an authorised specialist company! dehumidify rooms. Warning of electrical voltage The fan sucks damp room air through the air inlet, the air filter, Before any work on the device, remove the mains plug... - Page 5 Device depiction Designation Control panel Transport handle Wheels Air inlet with air filter Condensation drain hose connection Condensation tank Air filter Condensation drain hose Air outlet Colour LED for current room humidity dehumidifier TTK 53 E / TTK 72 E...
-
Page 6: Transport And Storage
Transport and storage Assembly and installation Note Scope of delivery If you store or transport the device improperly, the • 1 x Device device may be damaged. • 1 x Condensation drain hose, length: 0.3 m, Note the information regarding transport and storage of diameter: 10 mm the device. - Page 7 • When positioning the device, keep a sufficient distance to Inserting the condensation tank heat sources. • Ensure that the float inside the condensation tank is inserted correctly. • Make sure that no curtains or other objects interfere with the air flow. •...
-
Page 8: Operation
No. Designation Meaning Operation 16 MODE button Selection button for operating Notes: modes: • Avoid open doors and windows. Automatic mode • After being switched on, the device operates fully Dehumidification (additionally automatically. continuous operation) Laundry drying function • The fan permanently runs in dehumidification mode until Ventilation the set nominal value is reached. - Page 9 Dehumidification Laundry drying function The device keeps running until reaching the preselected relative The device may be used to dry clothes in a more timely manner. room humidity. Then the compressor switches off and the fan When positioning the device or a clothes horse, please observe keeps running and switches off with a delay.
- Page 10 Colour LED for current room humidity Operation with hose attached to the condensation connection Regardless of the operating mode, the colour LED indicates the current relative room humidity by means of 3 different colours. For continuous operation or unattended dehumidification, please connect the supplied condensation drain hose to the device.
- Page 11 3. Refit the condensation tank into the device. In doing so, Automatic defrost make sure that the condensation tank is inserted correctly, At low ambient temperatures, ice may form at the evaporator for otherwise the device cannot be switched back on. during dehumidification.
-
Page 12: Errors And Faults
• From the outside, check the condenser for dirt (see chapter Maintenance). If the condenser is dirty, have it cleaned by a specialist company or by Trotec. • The device might carry out an automatic defrost. During automatic defrost, the device does not dehumidify. -
Page 13: Maintenance
Maintenance intervals Maintenance Maintenance and care interval before every as needed at least every at least every at least every at least start-up 2 weeks 4 weeks 6 months annually Check air inlets and outlets for dirt and foreign objects and clean if necessary Clean the exterior Visually check the inside of the device for dirt... - Page 14 Maintenance and care log Device number: ........Device type: ..........Maintenance and care interval Check air inlets and outlets for dirt and foreign objects and clean if necessary Clean the exterior Visually check the inside of the device for dirt Check the air filter for dirt and foreign objects and clean or replace if necessary...
- Page 15 Tasks which require the housing to be opened and faults). must only be carried out by authorised specialist companies or by Trotec. 1. Remove the air filter from the device. Cleaning the housing Clean the housing with a soft, damp and lint-free cloth. Ensure that no moisture enters the housing.
- Page 16 4. Reinsert the air filter into the device. 2. Empty the condensation tank over a drain or sink. 3. Rinse the tank with clear water. Clean the tank regularly using a mild cleaning agent (no detergent!). 4. Refit the condensation tank into the device. Make sure not to damage the float when inserting or removing the condensation tank.
-
Page 17: Technical Annex
Technical data Technical annex Parameter Value Model TTK 53 E TTK 72 E Dehumidifying capacity max. 16 l / 24 h 24 l / 24 h Air volume 195 m 195 m Operating range (temperature) 5 °C to 32 °C 5 °C to 32 °C Operating range (relative humidity) 30 % to 80 % RH 30 % to 80 % RH Pressure suction side... - Page 18 Trotec GmbH & Co. KG Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...