KATflow 230
3 Installation
3.1 Unpacking and storage
3.1.1 Unpacking
Care should be taken when opening the box containing the flowmeter, any mark-
ings or warnings shown on the packaging should be observed prior to opening. The
following steps should then be taken:
Unpack the flowmeter in a dry area.
●
The flowmeter should be handled with care and not left in an area where it
●
could be subject to physical shocks.
If using a knife to remove packaging care should be taken not to damage
●
the flowmeter or cables.
The flowmeter package and contents should be checked against the deliv-
●
ery note supplied and any missing items reported immediately.
The flowmeter package and contents should be checked for signs of dam-
●
age during transport and any problems reported immediately.
The vendor accepts no responsibility for damage or injury caused during
●
the unpacking of the instrumentation supplied.
Excess packing materials should be either recycled or disposed of in a suit-
●
able way.
3.1.2 Storage
If storage is necessary, the flowmeter and sensors should be stored:
in a secure location,
●
away from water and harsh environmental conditions,
●
in such a way as to avoid damage,
●
small items should be kept together in the bags and small plastic boxes
●
provided to avoid loss.
3.1.3 Identification of components
The following items are typically supplied (please refer to your delivery note for a
detailed description):
KATflow 230 portable flowmeter
●
Clamp-on sensors (usually one or two pairs depending on pipe sizes to be
●
measured)
Sensor extension cable(s) (optional)
●
Sensor mounting accessories
●
Coupling component
●
Measuring tape
●
Operating instructions
●
Calibration certificate(s) (optional)
●
Temperature measurement probes (optional)
●
Process output terminal box (optional)
●
3 Installation
9