KATflow 230
3.6.2 Electrical connections
3.7 Clamp-on sensor mounting
Before the sensors can be mounted
the installation location should have been determined,
●
a sensor mounting method should be chosen,
●
the flowmeter batteries must be sufficiently charged,
●
the sensors must be connected to the transmitter.
●
Depending on which sensor mounting method is being used, the clamp on sensors
are either mounted on the same side of the pipe (Reflection Mode) or on opposite
sides of the pipe (Diagonal Mode – See Section 2.5).
Drawing 3: Electrical connections overview KATflow 230
3 Installation
15