Measurements; Main Process Value (Pv) Display - U-F-M KATflow 230 Operating Instructions Manual

KATflow 230
Table 4: Quick setup wizard

4.5 Measurements

4.5.1 Main process value (PV) display

Measurement is started using the Quick Setup Wizard. Once all the parameters are
programmed, any subsequent power-on sequences will bring up the main PV dis-
play immediately.
Display screen
Use cursor keys to select Start Measurement.
Confirm by pressing <ENTER>.
Sensor placement screen: Mount transducers
with suggested spacing and use middle bar for
fine adjustment of position (central position is
desired). Observe signal-to-noise (upper bar)
and quality (lower bar). These should be of
identical length.
Confirm by pressing <ENTER> to obtain
measurements.
Success!
Operation
The main process value can be changed
using the menu structure.
Press <ESC> at any time to return to the
main menu.
Change to the totalizer display, the 3-line
display, and dual display mode by pressing
<NEXT>, or to the diagnostic screens by
pressing <DISP>.
4 Operation
25