Danfoss VLT FC 51 Quick Manual page 18

Quick Guide
Analog Inputs
Number of analog inputs
Terminal number
Voltage mode (Terminal 53)
Current mode (Terminal 53 and 60)
Voltage level
Input resistance, R
i
Max. voltage
Current level
Input resistance, R
i
Max. current
Analog output
Number of programmable analog outputs
Terminal number
Current range at analog output
Max. load to common at analog output
Max. voltage at analog output
Accuracy on analog output
Scan interval
Resolution on analog output
Scan interval
Control card, RS-485 serial communication
Terminal number
Terminal number 61
Control card, 24 V DC output
Terminal number
Max. load (M1 and M2)
Max. load (M3)
Max. load (M4 and M5)
Relay output
Programmable relay output
Relay 01 Terminal number
Max. terminal load (AC-1) 1) on 01-02 (NO) (Resistive load)
1)
Max. terminal load (AC-15) on 01-02 (NO) (Inductive load @ cosφ 0.4)
1)
Max. terminal load (DC-1) on 01-02 (NO) (Resistive load)
1)
Max. terminal load (DC-13) on 01-02 (NO) (Inductive load)
Max. terminal load (AC-1) 1) on 01-03 (NC) (Resistive load)
1)
Max. terminal load (AC-15) on 01-03 (NC) (Inductive load @ cosφ 0.4)
1)
Max. terminal load (DC-1) on 01-03 (NC) (Resistive load)
Min. terminal load on 01-03 (NC), 01-02 (NO)
Environment according to EN 60664-1
1) IEC 60947 part 4 and 5
Control card, 10 V DC output:
Terminal number
Output voltage
Max. load
NOTE
All inputs, outputs, circuits, DC supplies and relay contacts
are galvanically isolated from the supply voltage (PELV)
and other high-voltage terminals.
®
VLT Micro Drive Quick Guide
®
MG02B702 - VLT is a registered Danfoss trademark
Switch S200=OFF(U)
Switch S200=ON(I)
approx. 10 kΩ
0/4 to 20 mA (scaleable)
approx. 200 Ω
Max. error: 0.8% of full scale
68 (P,TX+, RX+), 69 (N,TX-, RX-)
Common for terminals 68 and 69
01-03 (break), 01-02 (make)
250 V AC, 2 A
250 V AC, 0.2 A
24 V DC, 0.1 A
250 V AC, 2 A
250 V AC, 0.2 A
24 V DC 10 mA, 24 V AC 20 mA
overvoltage category III/pollution degree 2
1 1
2
53, 60
0-10 V
20 V
30 mA
1
42
0/4-20 mA
500 Ω
17 V
4 ms
8 bit
4 ms
12
100 mA
50 mA
80 mA
1
30 V DC, 2 A
30 V DC, 2 A
50
10.5 V ±0.5 V
25 mA
17