Step 14 - Adjust Factory-Installed Options; Step 15 - Install Accessories - Carrier WeatherMaker 48FC04-07 Installation Instructions Manual

Step 14 — Adjust Factory-Installed Options
SMOKE DETECTORS
Smoke detector(s) will be connected at the Unit Control Board
(UCB), at terminals marked "Smoke Shutdown." Detach the
jumper covering the Smoke Shutdown terminals on the UCB
and then attach the wiring harness from the smoke detector.
ECONOMI$ER IV OCCUPANCY SWITCH
®
See Fig. 54 for general EconoMi$er IV wiring. External occu-
pancy control is managed through a connection on the Unit Con-
trol Board.
If external occupancy control is desired, connect a time
clock or remotely controlled switch (closed for Occupied,
open for Unoccupied sequence) at terminals marked OCCU-
PANCY. Detach the jumper covering the "Occupancy" termi-
nals on the UCB and then attach the required connections.
Step 15 — Install Accessories
Available accessories include:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Refer to separate installation instructions for information
on installing these accessories.
Fig. 54 — EconoMi$er IV Wiring
42
Roof curb
Thru-base connection kit (must be installed before unit is
set on roof curb)
LP conversion kit
Flue discharge deflector
Manual outside air damper
Two-position motorized outside air damper
EconoMi$er ® IV (with control)
EconoMi$er2 (without control/for external signal)
Power Exhaust
Differential dry-bulb sensor (EconoMi$er IV)
Outdoor enthalpy sensor
Differential enthalpy sensor
CO sensor
2
Louvered hail guard
Motormaster ® head pressure controls
Phase monitor control