Ironing With Steam Spray; Setting The Steam Iron Temporarily Aside; Putting The Steam Iron Away After Use; Drip-Stop Function - Silvercrest SDB 2000 A1 Operating Instructions Manual

Ironing with Steam Spray

The steam spray is especially suited to smoothing
places in the laundry that are difficult to access.
• Raise the steam iron a little way.
• Press the steam spray button to release the steam
i
spray .
Setting the Steam Iron
Temporarily Aside
Fire Hazard!
Never leave the steam iron unattended when it is
hot or switched on.
• Set the temperature control
"MIN".
• Only put the steam iron down on its standing
e
foot , fig. 2.
Putting the Steam Iron Away
After Use
• Remove the power plug from the power socket.
• Empty the water reservoir and clean the gliding
r
sole .
• Place the cool steam iron horizontally on a soft,
clean base.

Drip-Stop Function

With conventional steam irons it can happen that
water drips from the iron sole
temperatures. This iron however possesses a new
equipment characteristic, the Drip-Stop function:
At low temperatures the iron automatically switches
off the supply of water for generating steam (for
steam blast and steam ironing). When this happens,
a "CLICK" is to be heard.
a
to the position
r at too low ironing
- 5 -
This prevents water dripping from the soleplate.
You must then re-set a suitable temperature with the
a
temperature controller
steam production is continued.
Additionally, if you set the steam iron down or just
let it cool off, the drip-stop function prevents water
leakage from the soleplate

Cleaning

Self-cleaning function

• Fill the water container up to the marking MAX.
• Insert the plug into the power socket.
• Set the temperature regulator
MAX.
• Let the iron warm up till the control light
off and lights up again.
• Hold the iron horizontally over a trap vessel.
• Set the steam regulator
and hold it in this position. Now steam and boiling
water will start emerging from the steam escape
holes at the gilding sole
will get washed out.
• Release the steam regulator
water in the water container is used up.
• To ensure that no water remains in the steam
chamber, dry the gilding sole
this purpose, wipe the gilding sole
times on a towel or an old cloth.
• Allow the iron to cool down before storing it
away.
Note:
The effect of the self-cleaning function can diminish
after extended usage of the iron. We therefore re-
commend the addition of decalcification agent into
the water tank.
. As soon as this is reached,
r
.
a
to the position
w
u
to Self-Clean position
r
. Any dirt, if present,
u
as soon as the
r
thoroughly. For
r
a few
cuts