Cisco 7925G-EX Administration Manual page 11

Wavelink Avalanche Server
If you uncheck all channels in the 802.11 G Power Settings or 802.11 A Power Settings, the phone will
Note
not be able to access the WLAN.
Related Topics
Network Profile Settings
USB Settings Field
You can change the IP address of the USB port on your phone by choosing one of the following options in
the DHCP Enabled field:
Yes
No
Related Topics
Set Up USB Settings on PC
Trace Settings Fields
You can configure trace settings to determine how the phone creates and saves trace files. The following table
describes the trace settings.
Table 3: Trace Settings
Item
Number of Files
Enable Remote Syslog
Remote IP Address
Remote Port
Kernel Level
Configuration Level
Call Control Level
Obtains an IP address automatically.
You can specify the IP address and subnet mask on this page.
Description
Choose the number of trace files that the phone saves, from 2 to 10 files.
Set up a remote server to store trace logs. If enabled, enter remote address and
remote port.
Enter remote IP address if Enable Remote Syslog is enabled.
Enter a port number if Enable Remote Syslog is enabled. Valid values are: 514
and 1024 to 65535.
Operating System data.
Phone configuration data.
Cisco Unified Communications Manager data.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
USB Settings Field
11