Pendant Transceivers; Activate The Pendant Battery; Set Up The Pendant - RF Technologies CODE ALERT Quick Response Premiere Wireless Call System Hardware Installation Manual

Pendant Transceivers

The Pendant transceiver is a wireless, mobile transceiver that can be worn around the neck or wrist, or attached
to a belt. The protective boot protects the Pendant transceiver against dropping and water ingress. However, to
prevent water damage, avoid prolonged submersion and direct contact with a water stream.
The Pendant has one (1) light that is visible from the outside of the enclosure. The light flashes 3 times in rapid
succession when the alarm is triggered or cleared. A green light indicates communication with the Gate-
way/Router is good; red indicates communication failure and the device is not transmitting to the Gate-
way/Router.
The Pendant can be supervised; if no information is received by the system from the Gateway for a specified
supervision time, a No Signal alarm is generated in the Event List at the computer. Since the Pendant is a
mobile device, no installation is required.

Activate the Pendant Battery

The Pendant is shipped with a replaceable 3V coin cell battery. To activate the battery, use your fingers
to re-move the back cover and pull out the plastic battery tab. Be sure the battery stays in the battery
holder while the plastic tab is removed. Additionally, make certain that you are not pressing on the blue
button while activating the battery.

Set up the Pendant

With the Pendant transceiver within range of the system, alarm the Pendant by pressing and releasing the
blue button. If the alarm message has been delivered successfully, the green light will flash 3 times.
The green light will then blink once every 3 seconds while the Pendant remains in alarm. The system
senses the Pendant when it goes into alarm.
Quick Response Premiere Wireless Call System Hardware Installation Guide
0510-1099-E
CHAPTER 2 Installing Transceiver Devices
Page 47 of 64