Table of Contents
Advertisement
Rebuild Subnet on Scanned Devices
This option is used to rebuild the subnet on scanned devices.
1.
Select Login (or Functions if password protection is disabled).
2.
Enter your Login and Password or use your identification card.
3.
Press Enter or click OK.
4.
Select Administrative Functions.
5.
Select Configuration. The Configuration page opens with links to the Configuration
menus.
All devices recognized by the system are listed in the Configuration Device window.
6.
Select Devices.
The Configuration devices window opens.
7.
Click the Properties box next to the Gateway.
The Configuration Device Properties window opens.
FIGURE 1.5: Configuration Device Properties
8.
Click the checkbox next to Rebuild subnet on next scan.
9.
Click Save and then Close the window.
10. You must execute the Scan command on that Gateway's comport to begin.
Quick Response Premiere Wireless Call System Hardware Installation Guide
0510-1099-E
WARNING: Rebuilding the subnet should only be done when end devices
are not present during installation. During the Rebuild, the system will be
down for up to 10 minutes.
CHAPTER 1 Installing Hardware Components
Page 31 of 64
Advertisement
Table of Contents
Need help?
Do you have a question about the CODE ALERT Quick Response Premiere Wireless Call System and is the answer not in the manual?
Questions and answers