Replacement Nozzle; Throttle Adjusting Parameter - Maruyama MS0741 Operator's Manual

Replacement nozzle

(1)Round nozzle 25 (Optional accessory)
Exclusive nozzle for round up weed killer.
(2)Replacement nozzle tip C-6 (Optional acces-sory)
a. Using replacement nozzle tip, about 1.5
times of spray volume is available com-
pare to standard nozzle.
b. When large volume of spray or large vol-
ume of spray at low pressure is necessary,
this replacing nozzle can be used.
c. C-6 is indicated on the surface of replace-
ment nozzle tip.(C-35 is standard)
d. Replacement can be done by loosening
the screw of the nozzle cap. When replac-
ing, stop the machine. Close ball valve.
Nozzle tip
Packing
Spray pipe
Cap

Throttle adjusting parameter

(1) Standard setting is parial throttle position. (See
fig1)
Adjuster
Fig 1
(2) In order to perform full throttle, lose the bolt and turn
right 90 degree the adjuster. (See fig2) Adjuster must
be the top position on length hole. (See fig3) Then,
tight the bolt and check fixing adjuster.
Turn
right
Fig 2
Top position
Fig 3
(3) In order to perform standerd setting, lose the
bolt and turn left 90 degree adjuster. (See fig4)
Adjuster must be the top position on length
hole. (See fig3)
Turn left
Fig 4
Then, tight the bolt and check fixing adjuster.
20
Bolt
Length hole
Bolt
English