Handling And Operating Methods; Nozzle Assembling; Checking The Battery Remainder (Battery Remainder Determination Method) - Maruyama MSB15LiZ Owner's/Operator's Manual

2). Shoulder band
(1) To shorten band
Pull the sling downward along the front hanging
band.
3. Handling and operating method

Nozzle assembling

First ensure that the gasket is put in place, screw
the lance into the grip, and tandem nozzle head
into the lance. In that step, check the gasket in
place to prevent water leakage, and then tighten
the screw securely. Be sure to tighten it while
refraining the excessive tightening, which will
cause the gasket to stick out.

Checking the battery remainder (Battery remainder determination method)

(1) Pour approximately 1 liter of water into the chemical tank.
(2) Turn the switch ON, wait until the pump sucks water to raise the pressure, and then check the graduation
of the battery balance meter.
Recharging
Yellow
Must be recharged
Red
and may causes a failure.
green zone.
(2) To lengthen the band
Insert the front handing band upward.
Operable
Yellow
Red
For recharging details,refer to descriptions on Page 9.
If operation continues after the remaining battery icon
- 6 -
Tandem nozzle head
Operable
Recharging
Must be recharged
English