Operation Instructions; Electronic Controls; Beer Temperature - Danby Silhouette DKC646BLS Owner's Manual

Electronic Controls

TEMPERATURE INCREASE
TEMPERATURE DECREASE
LED DISPLAY
FAHRENHEIT MODE
CELSIUS MODE
FAHRENHEIT/CELSIUS SELECTOR
The electronic control panel allows for total cabinet
temperature control as well as the option of
displaying (current) and modifying (setting) the
cabinet temperature in either Fahrenheit or Celsius.
When you first plug in your Keg Cooler the LED will
display the 'live' cabinet temperature in Fahrenheit
and the thermostat will be set to 41º F (5º C). The
following paragraphs will explain how to modify the
aforementioned settings to suit your requirements;

Beer Temperature

Correct consistent temper-
ature is an important factor
to consider when storing
and dispensing draught
beer. Therefore, please
adhere to the following
guide lines;
OPERATING INSTRUCTIONS
• Beer can freeze, so it is important to select and
maintain proper operating temperatures inside
the refrigerator cabinet. * Beer will start to
freeze at 28º F ( - 2º C)
• Optimum temperatures for serving cold beer are
36º ~ 40º F (2º ~ 4º C)
• Temperatures too cool or too warm may cause
flavor loss, off taste and dispensing problems.
• Periodically monitor temperatures inside your keg
cooler (adjust as necessary).
• Keep the keg cooler door closed as much as
possible to avoid temperature fluctuations.
Adjusting the temperature;
• Press either
enter the 'SET' mode. The LED display will begin
to flash and show the previous temperature
setting - signifying the temperature is ready to be
adjusted.
• Each depression of the
increase or decrease the temperature
incrementally by 1º (F/C) until the desired setting
is reached. The temperature can be set between
36-46º F (2-8º C).
*Note: the display will flash for 5 seconds from
the time the last button was activated before
resuming display of the internal temperature of
the cabinet.
Changing the temperature display;
• Press the
display between Fahrenheit and Celsius. The
corresponding pilot light adjacent to the selector
will aluminate to signify which unit of temperature
has been selected for display.
* Please Note: In the event of a power failure,
any modified settings are lost and the default
settings are restored once power resumes.
14
button once and release to
or will
selector button to alternate the