1. IGMP querier mode is globally enabled.
Using Web GUI:
Figure 9
Advance Application > Multicast > IPv4 Multicast > IGMP Snooping
2. The CLI shows a "No last querier is found".
Using CLI:
Figure 10
Enter CLI command "show igmp-snooping querier"
*The "No last querier is found" only means that there are no other active
IGMP queriers in the network. This does not indicate whether this device is the
active IGMP querier.
If both indicates that the switch is the active querier, go to step 3.
If both does not indicate that the switch is the active querier, go to step 8.
www.zyxel.com
45/132