*This example ensures that IP address 192.168.1.32~192.168.1.63 is processed
in VLAN 10.
Using CLI:
Figure 19
Enter CLI command "show subnet-vlan"
If traffic should hit Protocol Based VLAN criteria,
Verify that device with issue's IP address hits the correct protocol.
l
Verify that device with issue is connected under the correct port.
l
Verify that protocol traffic is sent to the destination's VLAN.
l
Using Web GUI:
Figure 20
Advance Application > VLAN > VLAN Configuration > Protocol
Based VLAN Setup
Using CLI:
Figure 21
Enter CLI command "show interface config Port-ID
protocol-based-vlan"
www.zyxel.com
35/132