Remote Control Device Installation - TOHATSU MFS 30C Owner's Manual

ENOW00945-0
CAUTION
Please inspect whether there is a loosen-
ing of the clamp screw or mounting bolts
before departure.
Loosening may cause a dangerous situa-
tion, such as loss of control.
PTT type
1. To attach the outboard motor to the
boat, use the bolts to secure the
outboard motor brackets on transom
board.
1
2
1. Bolt (12 × 105)
2. Washer (small diameter)
3. Nut
4. Washer (large diameter)
351 (13.82)
327 (12.87)
163.5
Ø12.5
125.5
251 (9.88)
4
3
ENOF00017-A
163.5
Ø12.5
125.5
ENOF00018-A
ENOW00008-A
CAUTION
Mounting bolts should be installed with
the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-0
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the
transom board holes before tighten-
ing the bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
ENOM00840-0
2. Remote control device
installation
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a posi-
tion where it is easy to reach and oper-
ate the controls.
25
INSTALLATION
5
3
1, 2
ENOF00841-1