Oil Filter Replacement - TOHATSU MFS 30C Owner's Manual

ENON00920-0
Note
Use only recommended engine oil (See
page 13)
10W−40
10W−30
-30 -20 -10 0 10
-22 -4 14 32 50
Oil volume needed for complete oil replacement
With oil filter replace-
ment
1800 mL
(63.3 fl.oz.)
ENOW00925-0
CAUTION
Wipe off engine oil well imme diately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
ENON00031-0
Note
If any amount of water is found in
engine oil, making it milky white, con-
sult dealer.
If engine oil is contaminated with fuel,
emitting strong fuel smell, consult
dealer.
Some oil dilution is normal if engine is
idled or trolled for long periods, espe-
cially in cooler water temperatures.
20 30 40 ˚C
68 86 96 ˚F
ENOF00208-0
Without oil filter
replacement
1600 mL
(56.3 fl.oz.)
INSPECTION AND MAINTENANCE
ENOM00092-A

Oil filter replacement

ENOW00091-0
CAUTION
You may be injured due to high engine tem-
peratures if you fill engine oil just after stop-
ping. Changing engine oil should be done
after the engine has been cooled.
ENOW00926-0
CAUTION
Wipe off engine oil well imme diately if
spilled and dispose of it in accordance with
local fire prevention and environment pro-
tection regulations.
1. Drain oil from the engine.
2. Place a rag or towel below the oil fil-
ter to absorb any spilled oil.
3. Unscrew old filter by turning the fil-
ter to counter clockwise.
4. Clean the mounting base. Apply film
of clean oil to O-ring.
Do not use grease.
Install oil filter and tighten it to specified
torque by using oil filter wrench.
Oil filter torque:
18 N·m (13 ft lb, 1.8 kgf
·
ENON00028-A
Note
If a torque-wrench is not available when
you are fitting a oil filter, a good estimate
of the correct torque is 3/4 to 1 a turn
past finger-tight. Have the oil filter
adjusted to the correct torque as soon as
possible with a torque-wrench.
69
10
m)
·