Assembly For Wall Mounting - Weston 05-0201 Instructions Manual

ASSEMBLY FOR WALL MOUNTING

YOU WILL NEED:
10mm Wrench or
an Adjustable Wrench
Two 3/8" Bolts and Washers
Wall Anchors
NOTICE: These instructions
only are for assembling the
Apple & Fruit Crusher for wall
mounting. It is the user's
responsibility to properly
mount the Crusher.
WARNING! The Apple &
Fruit Crusher is very heavy.
Make sure the wall is solid
and stable before mounting
the Crusher to it. Failure to
properly mount the Crusher
may result in serious personal
injury!
1. Stand the Apple Crusher
Main Body upright on a flat,
level surface with the Back
Side facing toward you.
2. Align holes A, B, E & F on
the Mounting Board with Feet
A, B, E, & F (FIGURES 8 &
9). The side of the Mounting
Board with the stepped holes
should face toward you.
3. Secure the Mounting Board
to the Feet with the Carriage
Bolts, Flat Washers and Hex
Flange Nuts (FIGURE 10).
Use a 10-mm wrench or an
adjustable wrench to tighten
the Hex Flange Nuts.
CAUTION!
8
To avoid personal injury, DO
NOT touch the stainless steel
Blades on the Wooden Drum.
Back Side
Foot
Mounting
Board
Stepped hole
Mounting
FIGURE 8
FIGURE 9
FIGURE 10
in the
Board