Assembly For Table Mounting - Weston 05-0201 Instructions Manual

ASSEMBLY FOR TABLE MOUNTING

The Apple & Fruit Crusher can be
used on a Table Top or Mounted to
a wall.
The Apple & Fruit Crusher comes
pre-assembled to the Mounting
Board.
TOOLS YOU WILL NEED:
10mm Wrench or an
Adjustable Wrench
Note: The Apple & Fruit Crusher
comes with the Mounting Board
attached for use on a table top.
Begin at Step 5 to complete the
assembly.
1. Set the Apple & Fruit Crusher on
its back side on a flat, level surface
with the feet facing toward you.
2. Align holes A, B, C & D on the
Mounting Board with Feet A, B, C,
& D (FIGURES 1 & 2). The side of
the Mounting Board with the stepped
holes should face toward you.
3. Secure the Mounting Board to
the Feet with the Carriage Bolts,
Flat Washers and Hex Flange Nuts
(FIGURE 3). Use a 10-mm wrench
or adjustable wrench to tighten the
Hex Flange Nuts.
4. Stand the Apple & Fruit Crusher
upright on the Mounting Board.
6
Back Side
Foot
Mounting
Board
Stepped hole
in the
Mounting
Board
FIGURE 1
FIGURE 2
FIGURE 3