Verify Anti-Tip Bracket Is Installed And Engaged; Electronic Ignition System - Whirlpool WEG515S0FB0 Installation Instructions Manual

Burner caps should be level when properly positioned.
If burner caps are not properly positioned, surface burners
will not light. The burner cap should not rock or wobble
when properly aligned.
A. Incorrect
B. Correct
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
6. Plug into a grounded 3 prong outlet.
Verify Anti-Tip Bracket Is Installed
and Engaged
1. Slide range into final location, making sure rear leveling
leg slides into anti-tip bracket.
2. Remove the storage drawer. See the "Remove/Replace
Drawer" section.
3. Use a flashlight to look underneath the bottom of the range.
4. Visually check that the rear range foot is inserted into the
slot of the anti-tip bracket.

Electronic Ignition System

Initial Lighting and Gas Flame Adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to the
"ignite" position, the system creates a spark to light the burner.
All cooktop burners will spark, but only the burner with the
control knob turned to the "ignite" position will produce a flame.
This sparking continues as long as the control knob is turned to
the "ignite" position.
When the oven control is turned to the desired setting, sparking
occurs and ignites the gas.
Check Operation of Cooktop Burners
Standard Surface Burners
Push in and turn each control knob to the "ignite" position.
The flame should light within 4 seconds. The first time a burner
is lit, it may take longer than 4 seconds to light because of air in
the gas line.
If Burners Do Not Light Properly:
I
I
A
I
I
B
Repeat start-up. If a burner does not light at this point, turn the
control knobs to the "off" position and contact your dealer or
authorized service company for assistance. Please reference the
"Warranty" section of the User Guide to contact service.
If the cooktop low burner flame needs to be adjusted for any of
the burners, see the "Adjust Flame Height" section.
1. Press BAKE.
2. Press the Start pad.
3. After 2 minutes, open the oven door and check that the
If Burner Does Not Light Properly:
I
I
I
Repeat steps 1 to 3. If the burner does not light at this point,
press the off pad and contact your dealer or authorized service
company for assistance. Please reference the "Warranty" section
of the User Guide to contact service.
If the bake burner flame needs to be adjusted, see the "Adjust
Flame Height" section.
Refer to the User Guide for proper operation of the oven controls.
1. Close the oven door.
2. Press BROIL.
3. Press the Start pad.
4. After 2 minutes, open the oven door and check that the oven
If Burner Does Not Light Properly:
I
I
I
Repeat steps 1 to 3. If the burner does not light at this point,
press the Off keypad and contact your dealer or authorized
service company for assistance. Please reference the "Warranty"
section of the User Guide to contact service.
If the broil burner flame needs to be adjusted, see the "Adjust
Flame Height" section.
Refer to the User Guide for proper operation of the oven controls.
Turn cooktop control knob to the "off" position.
Check that the range is plugged into a grounded 3 prong
outlet. Check that the circuit breaker has not tripped or the
household fuse has not blown.
Check that the gas shut-off valves are set to the open position.
Check that burner caps are properly positioned on burner
bases.
Check Operation of Oven Bake Burner
The oven burner should light within 8 seconds. The first
time a burner is lit, it may take longer than 8 seconds to
light because of air in the gas line.
oven is warm.
Press the Off pad.
Check that the range is plugged into a grounded 3 prong
outlet. Check that the circuit breaker has not tripped or the
household fuse has not blown.
Check that the gas shut-off valves are set to the open
position.
Check Operation of Oven Broil Burner
The oven burner should light within 8 seconds. The first time
a burner is lit, it may take longer than 8 seconds to light
because of air in the gas line.
is warm.
Press the Off pad.
Check that the range is plugged into a grounded 3 prong
outlet. Check that the circuit breaker has not tripped or the
household fuse has not blown.
Check that the gas shut-off valves are set to the open position.
11