Harken Carbo Racing Foil Instruction Manual

Harken Carbo Racing Foil Instruction Manual

Unit 0, 1, 2, 3

Advertisement

Quick Links

Carbo Racing Foil
Instruction Manual
Unit 0, 1, 2, 3
WARNING!: Strictly follow all instructions to avoid
an accident, damage to your vessel, personal injury
or death. See www.harken.com for additional safety
information.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Carbo Racing Foil and is the answer not in the manual?

Questions and answers

Summary of Contents for Harken Carbo Racing Foil

  • Page 1 Carbo Racing Foil Instruction Manual Unit 0, 1, 2, 3 WARNING!: Strictly follow all instructions to avoid an accident, damage to your vessel, personal injury or death. See www.harken.com for additional safety information.
  • Page 2 6-32x.5 Trusshead Screw HFS1049 6-32x.375 Barrel Nut HFS1093 6-32x.875 Flathead Screw Recommended height above deck: HFS347 8-32x.5 Trusshead Screw Feeder: 42"(110cm). HFS1139 8-32x.5 Barrel Nut Prefeeder: 30" (76cm). HFS1138 8x32x1 Flathead Screw 05/04/09 Unit 0, 1, 2, 3 Carbo Racing Foil...
  • Page 3 3. CUT TOP END ONLY. Don't cut bottom of foil with Harken labels and ® Make sure headstay is taut on boat feeder hole. or stretched taut on ground before installation. 03-2008 Unit 0, 1, 2, 3 Carbo Racing Foil...
  • Page 4 Do not spray McLube to lubricate headstay and foil. See Maintenance Splay foil with screwdriver and pull onto stay. Once foil is started, stop on Page 8 for details. to install trim cap. Unit 0, 1, 2, 3 Carbo Racing Foil 02-2010...
  • Page 5 Push foil up as far as it will go. Measure 12" (300mm) below feeder and lash prefeeder to tube. Measure length from feeder to bottom of exposed stay, for lower spacer Tape prefeeder in place. tube length. 03-2008 Unit 0, 1, 2, 3 Carbo Racing Foil...
  • Page 6 To prepare for the rare occasion when a sail misfeeds, some grand prix sailors drill a small exit port (shown at right). If sail jams on hoist, lower until misfeed runs down into gap, then re-hoist. Unit 0, 1, 2, 3 Carbo Racing Foil 03-2009...
  • Page 7 Luff tape is damaged or film of McLube . Spray on shore, away from ® dirty Carbo Racing Foil and boat. Replace or repair as necessary. Clean sail luff tapes and lubricate with thin film of McLube . Spray on shore, away from ®...
  • Page 8 If storing mast down, foil should be reasonably straight, foil groove down to avoid water and ice buildup. Before stepping mast, use soap and water to clean Carbo Racing Foil grooves. Warranty For additional safety, maintenance and warranty information see www.harken.com or the Harken ®...

Table of Contents