Advertisement
Installation
1. Upper Spacer Tube
Splay 5" (127 mm) upper spacer tube
with flat bladed screwdriver, slip onto
stay and tape.
Important: Tape full length of
spacer tube.
2. Foil Start
Identify top of foil. Side groove
will be on starboard.
Tip: In cool
weather, use
a heat gun
to warm foil.
Splay foil with screwdriver and pull
onto stay. Once foil is started, stop
to install trim cap.
4
Tip: Foil installs easier if excess is
held out to starboard side of boat.
3. Trim Cap
Place trim cap on foil so slot is aft,
with large hole on starboard. Squeeze
together with pliers. Put blue Loctite
in barrel nut. Install two-piece screw
and barrel nut with Phillips screwdriver.
4. Foil
Snap foil into place by pulling aft with
one hand, while sliding foil up with
the other. Use heat gun.
Tip: Use liquid soap to lubricate
headstay and foil.
Do not spray McLube to lubricate
headstay and foil. See Maintenance
on Page 8 for details.
Unit 0, 1, 2, 3 Carbo Racing Foil
®
02-2010
Advertisement
