Section A.4 Installation; On Site Positioning; Connections; Electrical Connections - BeaconMedaes Lifeline Camel Installation, Operation And Maintenance Manual

"Camel" Liquid Ring Medical Vacuum
A.4 Installation
A.4.1

On Site Positioning

The "Delta" EC pumps do not require any specialized foundations in order to be mounted. The pump should be set
horizontally on an even surface and fixed through the motor feet on close-coupled pumps, or through the bracket
feet on pedestal mounted pumps. If there are motor feet present on pedestal mounted pumps, do not bolt the motor
feet to the foundation. The motor feet should be left freestanding. When lifting the pump with a crane, use the hoist
cable locations as shown in the diagram below. Please be sure that the hoisting device is of sufficient capacity to
handle the loading.
A.4.2

Connections

A.4.2.1 Electrical Connections
Before carrying out any work, open, lock, and tag out the main circuit
breaker. Electrical connections should be made in compliance with all local
Check motor power, voltage, frequency, and phase against those listed on the motor nameplate. Voltage is to be
within +5% and frequency within +2% in order to being in acceptable limits. Motor is to be properly grounded.
A.4.2.2 Inlet and Discharge Connections
The pump is shipped with the suction and discharge ports closed by protection caps, which should be removed only
when connecting the piping. The inlet and discharge connections are vertical and are marked with arrows cast into
the pump. The piping to the connections should not have diameters smaller than those of the connections and the
load should not rest on the flanges. All piping is to be properly supported such that no loading is placed on the
pump. Handle all gaskets carefully. Gaskets must be set between the flanges concentrically, so as not to create any
obstruction or reduce the flow section.
WARNING
and federal regulations.
A-5
Medical Systems