Table of Contents
Advertisement
Advice:
If the hose is long and the room temperature low, the moisture might condense inside the
hose. This is an unavoidable natural phenomenon. To prevent this water from lying in the
hose or flowing back into the tumble dryer, it is advisable to drill small hole (dia.3 mm) in
the lowest point of the hose and to place a small container below it. (See picture, point B) .
Once connected to the dryer, run the vent hose to the desired outlet point, it contains
no more than two bends. As to the outlet itself, if you have decided on a fixed
wall/window grille, a good local builder's merchant should be able to supply you with
the necessary fittings and installation advice.
It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe
designed to carry the exhaust from a fuel burning appliance.
Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry
its auste outside the kitchen.
In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed.
If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially
squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption.
If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate.
Electrical connection
Any electrical work required to install this
appliance should be carried out by a qualified electrician or competent person.
The manufacturer declines any liability should this safety measure not be observed.
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance's
rating plate.
Should the plug need to be replaced for any reason, proceed as described below.
The wires in the mains lead are coloured in accordance with the following code:
The wire coloured green and yellow must be connected to the terminal marked with the letter
earth symbol or coloured green and yellow.
A cut off plug inserted into a socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Permanent connection
Warning
In the case of permanent connection it is necessary that you install a double pole switch.
The switch must not break the yellow and green earth cable at any point.
Packaging materials
The materials marked with the symbol
>PE<=polyethylene
>PS<=polystyrene
>PP<=polypropylene
This means that they can be recycled by disposing of them properly in appropriate collection containers.
Old machine
Use authorized disposal sites for your old appliance. Help to keep your country tidy!
The symbol
on the product or on its packaging indicates that this product may not be treated as
are recyclable.
or by the
10
Advertisement
Table of Contents
